Introduction To Auto desk AutoCAD | DAY 16

Learn AutoCAD basics: DAY 16

In this Learn AutoCAD basics DAY, we have learned how to grow an array on an ellipse. Today we are going to combine that skill with others to complete today’s project.

That being said, we will suggest you to master the experiment we made on DAY 12 and the use of the ARRAY command in AutoCAD before trying this one out.



The following is the image of today’s experiment.


hey! If you have any confusion about this, Just leave a comment below. Let me know what is confusing about this, I will make it clear for you


Now, we would love to provide the following images. Those will contribute to make you see clearly how you should proceed .

You can notice an ellipse of 55 x 108 on the figure below, it is what you have to use to create the array. Those small circles are equally spaced around the path of the array.

The center of the Big circle is shown on the image below and denoted by A.


The following image gives a dimension that will be important while designing.


The red line on the last image shows a line of symmetry that will be used to get the down part of the object completed.

Note you will be required to use the OFFSET command in this exercise.

Add Comment

Click here to post a comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.