Introduction To Auto desk AutoCAD | DAY 10

Learn AutoCAD basics: DAY 10

One of the command we have not been using since the beginning of this series is the MIRROR command. We expect to force its use with today’s session.

Today’s rule will be a bit altered in the sense that we wish you use the MIRROR command. How? If you look closely at the image below you will notice that the object is a sort of symmetric. Imagine a vertical line cutting it into two, both sides will be just identical mirrored copies.

 

LEARNING AUTOCAD BASICS

Here is the object of today’s experiment.

learn-AutoCAD

We’ve said earlier that the object is symmetric, let’s see what a part of it would look like. (The line in red seeing as the line of symmetry)

learn-AutoCAD

After removing all FILLET, here is what the image looks like

learn-AutoCAD

Here are some information that might be helpful

learn-AutoCAD

You can just do the inverse operation to mount that object walking from the last image right above this to the first image we had in the beginning of this session.

Add Comment

Click here to post a comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.